TX & RX Accessories

TX & RX Accessories

Antennas and Radio accessories and Bling, tunig for all major radios

Products


  • JETI DS TX Handsender Deckelfolie Wood

    JETI DS TX Handsender Deckelfolie Wood

    JETI DS TX Handsender Deckelfolie Wood

    Brand new and exclusive at PimpYourJeti. Following the Custom Finish Design for the Goblin.
    Now finally as appropriate transmitter cover for your JETI transmitter in Blue Eye look.

    Adhesive decorative films for your JETI hand-held transmitter! 100% developed and produced in Germany.

    Easy installation!

    Disassembly of transmitter and removal of switches is not necessary!
    Make sure the surface of the transmitter is clean. For best results, the surface should be free from dust and grease.
    Lay the film on the surface and press lightly.
    Easy installation because of innovative bubble-free technology

    SKU: PYJ-JETI-08
    €49.90
    inc. VAT

  • JETI DS TX Handsenderfolie Orange Eyes

    JETI DS TX Handsenderfolie Orange Eyes

    JETI DS TX Handsenderfolie Orange Eyes

    Brand new and exclusive at PimpYourJeti. Following the Custom Finish Design for the Goblin.
    Now finally as appropriate transmitter cover for your JETI transmitter in Blue Eye look.

    Adhesive decorative films for your JETI hand-held transmitter! 100% developed and produced in Germany.

    Easy installation!

    Disassembly of transmitter and removal of switches is not necessary!
    Make sure the surface of the transmitter is clean. For best results, the surface should be free from dust and grease.
    Lay the film on the surface and press lightly.
    Easy installation because of innovative bubble-free technology

    SKU: PYJ-JETI-01
    €49.90
    inc. VAT

  • Jeti Replacement Switch for DC-16: Long 2 Position

    Jeti Replacement Switch for DC-16: Long 2 Position

    Jeti Replacement Switch for DC-16: Long 2 Position

    SKU: JMS-DC-TSL2
    €13.90
    inc. VAT

     LOW STOCK
  • Jeti Replacement Switch for DS-16: Long 3 Position

    Jeti Replacement Switch for DS-16: Long 3 Position

    Jeti Replacement Switch for DS-16: Long 3 Position

    SKU: JMS-DS-TSL3
    €13.90
    inc. VAT

     72HR STOCK
  • Jeti Replacement Switch for DS-16: Short 2 Position

    Jeti Replacement Switch for DS-16: Short 2 Position

    Jeti Replacement Switch for DS-16: Short 2 Position

    SKU: JMS-DS-TSS2
    €13.90
    inc. VAT

     72HR STOCK
  • Jeti Rx Bind Plug

    Jeti Rx Bind Plug

    Jeti Rx Bind Plug

    SKU: JETI-RX-BIND
    €1.90
    inc. VAT

     IN STOCK
  • Jeti Safety switch for DC-16

    Jeti Safety switch for DC-16

    Jeti Safety switch for DC-16

    SKU: JMS-DC-TSL2S
    €13.90
    inc. VAT

     72HR STOCK
    NEW
  • Jeti SPS 20 Single Electronic Switch

    Jeti SPS 20 Single Electronic Switch

    The SPS 20 (single electronic switch) is an electronic switch mainly meant to switch supply voltages of receivers / servos, regulators, fuel pumps or similar equipment. A big advantage of electronic switches in comparison to mechanical ones is in general their higher reliability as far as vibration resistance is concerned. Another advantage of the electronic switch is given by its practical ability to withstand an unlimited number of switching cycles.

    Electronic switches have no moving parts like contacts which would be wearing out during switching processes, therefore their durability is extremely long. Moreover, they are not prone to spontaneous and unexpected false tripping with known disastrous effects. Last but not least, electronic switches offer much lower inherent transient resistance in comparison to mechanical switches.

    The electronic switches SPS 20 are operated with the aid of a magnetic switch which can be fixed to the fuselage or elsewhere. The system becomes switched on or off with application of a special magnet.

    The switc SPS 20 is admittedly intended for the purpose of switching supply voltages of receivers and servos, but they may be as well successfully used for other DC switching tasks.

    • Weight [g]: 27
    • Dimensions [mm]: 46 x 45 x 6.5
    • Sustained current [A]: 10
    • Telemetry: No
    • Operational temperature [°C]: -20 ... 85
    • Recommended input voltage [V]: 3,5 ... 14
    • Idle current: 160
    • Number of battery inputs: 1
    • Input voltage max: 16V
    • Peak current (max 5s): 20A
    SKU: J-SPS-20
    €41.90
    inc. VAT

     72HR STOCK
  • Jeti Taster Long-Pos 3. for DC-16

    Jeti Taster Long-Pos 3. for DC-16

    Jeti Taster Long-Pos 3. for DC-16

    SKU: JMS-DC-TSLM
    €13.90
    inc. VAT

     72HR STOCK
    NEW
  • Jeti Telemetry Expander E2

    Jeti Telemetry Expander E2

    The EXPANDER E2 EX module is used to expand the number of connecting slots for further telemetric sensors. In this way it becomes possible to connect up to 2 sensors to a DUPLEX receiver. The expander can be set in a way which enables the JETIBOX to show several measured values simultaneously.

    Specification:

    • Weight [g]: 4
    • Dimensions [mm]: 27 x 14 x 5
    • Operational temperature [°C]: -10 ... 85
    • Supply Voltage [V]: 3,2 - 8,4
    • Average Current [mA]: 5
    SKU: JEX-2
    €32.90
    inc. VAT

     72HR STOCK
  • Jeti Telemetry Expander E4 EX

    Jeti Telemetry Expander E4 EX

    The modules EXPANDER E4 EX are used to expand the number of connecting places for further telemetric sensors. In this mannner it becomes possible to connect up to 4 sensors to a DUPLEX receiver. The expander can be set in a manner which enables the JETIBOX to show measured values of concern simultaneously.

    Parameters

    • Dimensions [mm]   36 x 20 x 5
    • Weight [g]   4
    • Temperature Range min.[°C]   -10
    • Temperature Range max. [°C]   +85
    • Supply Voltage min. [V]   3,2
    • Supply Voltage max. [V]   8,4
    • Average Current [mA]   8
    SKU: JEX-4
    €37.90
    inc. VAT

     LOW STOCK
  • Jeti Telemetry Sensor RPM Brushless motors

    Jeti Telemetry Sensor RPM Brushless motors

    Jeti RPM sensor EX for BL Motors

    The sensor MRPM EX-AC is used exclusively for measuring the speed of brushless DC motors (BLDC). It is connected to any two motor phases and it calculates the current speed from the electrical course at the phases. With the help of the sensor MRPM-EX AC, current speeds and the past course of the propeller performance (minimum, maximum) can be monitored.
    The sensor can be adjusted to set the timeout parameter which will be later announced to the user. Because the sensor is connected to the motor power system, the user must adjust the number of motor poles and the gear ratio of the transmission system to ensure proper operation. The information from the sensor are transmitted to the user via the Duplex system.

    Specification:
     

    • Weight [g]: 6
    • Dimensions [mm]: 19 x 14 x 4
    • Operational temperature [°C]: -10 ... 85
    • Supply Voltage [V]: 3,5 - 8,4
    • Average Current [mA]: 10
    SKU: JEX-MRPMAC
    €37.90
    inc. VAT

     LOW STOCK
  • Jeti Transmitter Brackets (Holder TX) DC-16/DS-16

    Jeti Transmitter Brackets (Holder TX) DC-16/DS-16

    Jeti Transmitter Brackets (Holder TX) DC-16/DS-16

    SKU: JMS-DC-B
    €29.00
    inc. VAT

     72HR STOCK
  • Jeti Transmitter Replacement Momentary Button Switch DC

    Jeti Transmitter Replacement Momentary Button Switch DC

    Jeti Transmitter Replacement Momentary Button Switch DC

    SKU: JMS-DC-TB
    €13.90
    inc. VAT

     72HR STOCK
  • Jeti Transmitter Replacement Momentary Button Switch DS

    Jeti Transmitter Replacement Momentary Button Switch DS

    Jeti Transmitter Replacement Momentary Button Switch DS

    SKU: JMS-DS-TB
    €13.90
    inc. VAT

     72HR STOCK
  • Jeti Transmitter Stick for DC/DS-16 & DS-14 - 2 position switch

    Jeti Transmitter Stick for DC/DS-16 & DS-14 - 2 position switch

    Jeti Transmitter Stick for DC/DS-16 & DS-14 - 2 position switch

    SKU: JMS-DC-SS2
    €39.90
    inc. VAT

     72HR STOCK
  • Jeti Transmitter Stick for DC/DS-16 & DS-14 - 3 position switch

    Jeti Transmitter Stick for DC/DS-16 & DS-14 - 3 position switch

    Jeti Transmitter Stick for DC/DS-16 & DS-14 - 3 position switch

    SKU: JMS-DC-SS3
    €39.90
    inc. VAT

     72HR STOCK
  • Jeti Transmitter Stick for DC/DS-16 & DS-14 - potentiometer

    Jeti Transmitter Stick for DC/DS-16 & DS-14 - potentiometer

    Jeti Transmitter Stick for DC/DS-16 & DS-14 - potentiometer

    SKU: JMS-DC-SP
    €49.90
    inc. VAT

     72HR STOCK
  • Jeti Tx Switch nut spanner

    Jeti Tx Switch nut spanner

    Jeti Tx Switch nut spanner

    SKU: JMS-DC-SNS
    €9.90
    inc. VAT

     72HR STOCK
  • Jeti USB Adapter

    Jeti USB Adapter

    The USB Adapter transfers information between a PC and Jeti model products.
    It is, in fact, an adaptation means between the PC USB interface and the data connector Ext. with appropriate USB support, provided in Jeti model products.
    All types of equipment marked with the label symbol USBa are prepared for firmware updates.
    SKU: J-USBA
    €16.90
    inc. VAT

     IN STOCK
  • Jeti voltage sensor EX to duplex system to 6s Lipo

    Jeti voltage sensor EX to duplex system to 6s Lipo

    MULi 6S EX is  a sensor for checking voltage of Li-XX batteries that checks the voltage by service connector of every single cell. It allows you to check the voltage up to 6 Li-XX cells.
    You can check voltage of every single cell, store its history (maximum, minimum), total voltage of the whole battery, and the sensor can also give notice of exceeding selected parameters. Data from the sensor are transferred via DUPLEX system.

    • Weight     6g
    • Dimensions [mm]    36 x 20 x 5
    • Operational temperature [°C]    -10 ... 85
    • Supply Voltage [V]    3,5 ... 8,4
    • Average Current [mA]    9
    • Range of measured voltage [V]    0 ... 4,4
    SKU: JEX-MULI6S
    €39.90
    inc. VAT

     72HR STOCK
  • JR Original Sticker White

    JR Original Sticker White

    JR Original Sticker logo JR White

    SKU: JR8608
    €8.90
    inc. VAT

     IN STOCK
  • JR Transmitter Neck Strap

    JR Transmitter Neck Strap

    JR Transmitter Neck Strap, fit all radios

    Original JR single-point neckstrap, orange. Width approx 30 mm.

    SKU: F1596JR
    €12.00
    inc. VAT

     LOW STOCK
  • JR-SPEKTRUM TX Switch Nuts

    JR-SPEKTRUM TX Switch Nuts

    JR and SPEKTRUM Transmitter SWITCH NUTS

    Full set including 8 pcs and Removal/installation tool. WILL NOT WORK ON THE 12X or 8103.

    You'll notice that the upper rim of the nut is smooth. Some Transmitters have the slots cut in the nuts had sharp corners. If you using to put the fingers between the switches, this got to be very irritating. Those nuts have smooth rim.
    The colors are just a bonus

    SKU: ELRC602G
    €16.00
    inc. VAT

     LOW STOCK

Manufacturers

Back