Radial Bearings

Radial ball bearing 8x16x5

Japanese made, ABEC5. set of 1 pcs

Radial ball bearing R2-5ZZ
Specially used in motors with 3.17mm shaft
Size: 0.125X.3125X.1406 inch
 

Radial ball bearing R2-ZZ
Specially used in motors with 3.17mm shaft
Size: 0.125x0.3750x0.1562 inch
 

Revell Rayvore & Dromida Ominus Bearing set replacement

This is a replacement Ball Bearing Set for the Rayvore & Dromida Ominus Quadcopter. Includes eight ball bearings for the four motor shafts.

Description:

Includes:

• ABEC-5 Ball Bearing 12 x 28 x 7mm (16001zz) - 2pcs

Scorpion HK-40 Motor Bearing Kit.

In order to keep your motor in top running condition, you need a good set of bearings. Occasionally, after a crash or landing in the dirt, the bearings can become damaged and need to be replaced.
The Scorpion HK-40mm Motor Bearing Kit includes a pair of original equipment replacement bearings to fit the Scorpion HK-40 & HKIII-40 Series motors.(Except HK-4015)

Please note, the bearings are an exact fit into the motor housings, so they do fit snugly. When removing the old bearings, you may need to gently tap them out. However, when installing the new bearings, do not tap them in with anything, as this can dent the ball races and ruin the bearings.
When installing ball bearings they need to be pressed in by the outer part of the race. Never apply pressure to the inner race, as this can damage the bearing and lead to premature failure.

Tail pitch control lever bearings - 2 pcs

Size: d4 x D7 x W2.5

Upgrade Stainless Steel  Front bearing for Nitro Engine OS 40-50-61-91-105,it fits Also other models, if you not sure, please contact us.

Stainless Steel bearings are made from heat hardened 440C stainless bearing stock.  This steel is hardened to well within the requirements for standard steel bearings.  Since it is a heat hardened stainless, it is magnetic!  It is actually referred to a corrosion resistant steel so tiny rust spots can appear on it but usually not enough to affect performance.  If you had rust issues with standard bearings, these will all but eliminate that problem

Those bearings are a direct upgrade to stock bearing delivered with OS engines. Bearing comes with 2 Rubber Shields/sealings. 1 should be removed in order to allow Oil to pass throw, this side is the Inner side, Outer side stays with Sealing.

Upgrade SS Rear bearing for Nitro Engine OS 40-55, YS50-56,it fits Also other models, if you not sure, please contact us.

Stainless Steel bearings are made from heat hardened 440C stainless bearing stock.  This steel is hardened to well within the requirements for standard steel bearings.  Since it is a heat hardened stainless, it is magnetic!  It is actually referred to a corrosion resistant steel so tiny rust spots can appear on it but usually not enough to affect performance.  If you had rust issues with standard bearings, these will all but eliminate that problem

Those bearings are a direct upgrade to stock bearing delivered with OS/ys engines. Bearing comes with 2 Rubber Shields/sealings. BOTH should be removed in order to allow Oil to pass throw.