MAUCH PL Sensor Hub X2-V2 with CFK enclosure

24.71 ex.Vat

72h stock

Purchase this product now and earn 60 Points!
SKU: HUB-X2-V2 Category: Brand: Mauch Electronic

MAUCH PL Sensor Hub X2-V2 with CFK enclosure
    
This sensor hub is to connect two PL-xxx current sensors in parallel. The current of both sensors will be summarized and passed to the FC. The voltage measurement of the LiPo packs will be collected from both sensors and passed through the Hub to the FC.

The main purpose of this hub is to replace existing protection circuits (like an ideal diode) and to monitor, that both paralleled LiPo’s supply the same current to the system.

Since we monitor the current of both batteries, we will find out very early when a LiPo starts to fail… before it is too late.

If the difference in current is larger than +/- 15%, the Alarm output will be ON to indicate the fault… the pilot should immediately land and check the batteries.

The I2C bus is for future integration.

To set up a complete system you would need:

  • 1x PL Sensor Hub X2
  • 2x Current sensor board:
  • 2x PL-050 = 2x50A = 0-100A Total
  • 2x PL-100 = 2x100A = 0-200A Total
  • 2x PL-200 = 2x200A = 0-400A Total
  • 1x Power supply, which can be any of the Premium-Line series BEC's

Specifications:

  • 39mm x 31mm x 9mm / 7g without cables and without enclosure
  • 42mm x 34mm x 10mm / 13g with enclosure and without cables
  • Delivery in PP box: 55 x 55 x 20mm / 27g

Scope of delivery:

  • 1x PL Sensor Hub X2
  • 1x CFK enclosure
  • 2x Sensor cable / Molex 1.25mm – 4p / L = 150mm
  • 1x Alarm output cable / Molex 1.25mm – 3p / L = 100mm

 

    Do NOT follow this link or you will be banned from the site!
    Out of Stock Notification We will inform you when the product arrives in stock. Please leave your valid email address below.
    You need to Login for joining waitlist.

    Main Menu

    Ask an expert

    Found a better price?