Kakute F7 HDV Flight Controller for DJI HD FPV System

38.02 ex.Vat

72h stock

Purchase this product now and earn 92 Points!
SKU: HBF7-HDV Category: Brand: Iflight RC fpv

The Kakute F7 HDV has all the features you’d expect from a top-tier Betaflight flight controller. A fast F7 processor lets it run all the latest features at top speed. Six hardware-based UARTS for all the peripherals you could want. All UARTS support inversion so Frsky users don’t need to stress about “uninvert hack”. An SD card slot lets you store basically unlimited blackbox logs.

The Kakute F7 HDV has a built in plug that connects to the Air Unit with the included cable. No soldering is required! It’s got an 18-watt voltage regulator for the Air Unit (twice as much as the AU pulls, just to make sure voltage stays rock solid).

The FC itself utilizes a power F7 processor and includes a BMP280 barometer and SCL/SDA port for use with external GPS/magnetometer unit (not included). There’s also a SD card slot blackbox for data logging purposes.

Features:

Supports Betaflight and Cleanflight.
High-performance / low-noise IMU. MPU6000 with 6-axis gyro and accelerometer.
Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA for use with external GPS/magnetometer units.
Dedicated boot loader button for easy firmware flashing.
Low-profile design fits into even very compact frames.
Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on “B+” pad only).
Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the KAKUTE F7 HDV monitors voltage directly from the power supply.
Filtered voltage output for clean, noise-free video. 2 On-board regulators output 5V and 8V. 5V output up to 1.5A to power peripherals such as receiver, FPV camera, or LED strip. 8V output up to 2A to DJI FPV VTx.
Supports BLHeli pass-through for easy ESC upgrade and configuration.

Specifications:

MCU: STM32F745 32-bit processor
IMU: MPU6000
Barometer: BMP280
USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
6 hardware UARTS (UART1,2,3,4,6,7)
All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without “uninvert hack”.
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.
TF card for Blackbox logging
Dimensions: 35x35mm
Mounting Holes: Standard 30.5mm square to the center of holes
Weight: 8g

Included:

  • 1 x FC board
  • 4 x M3 Damping Ball
  • 1 x JST SH 8pin 150mm cable
  • 1 x JST GHR 8pin to JST GHR 6pin 80mm cable

    eRCmarket
    Out of Stock Notification We will inform you when the product arrives in stock. Please leave your valid email address below.
    You need to Login for joining waitlist.

    Main Menu

    Ask an expert

    Found a better price?