YGE Aureus 135 Brushless Telemetrie controller 10/25A BEC

YGE Aureus 135 Brushless Telemetrie controller 10/25A BEC

Properties:

• 6-12s LiPo
• BEC 10A continue, 25A peak
• Receiver and telemetry cable pluggable
• 32-bit processor
• New RCT cooling concept enables lower temperature development and better heat dissipation in a smaller design
• super slow soft start for scale helicopters selectable (up to 60 sec.)
• High-precision current measurement and adjustable current limit
• Compatible telemetry protocols: Graupner HoTT V4, Jeti ExBUS, MPX Sensor BUS V2
• YGE protocol for further telemetry connections via e.g. YGE TexY (Futaba, Spectrum, FrSky), MSH Brain 2, Spirit FBL
• Update capability (optional USB adapter available)
• completely revised hardware and software (32-bit)
• PWM frequency is automatically adjusted to the needs of the motor
• The specified current is the maximum continuous full gas flow with good cooling
• Reset or shutdown in case of undervoltage
• Current limit
• Undervoltage detection can be switched off
• Speed ​​control (governor mode)
• soft start (sine or block commutation)
• Super slow soft start possible for scale helicopters (60sec.)
• Active freewheel, therefore unlimited part load
• Automatic timing, or adjustable in 6 levels
• EMK brake adjustable
• F3A / Acro brake (brake intensity steplessly adjustable in flight)
• Min and Max values ​​are logged and can be displayed after the flight in the optional PC tool (e.g., power)
• Speed ​​limit: 240,000 rpm (2-pole)
• Overtemperature / overload warning
• Anti-fog: reduces the starting spark
• Basic programming via mode setup
• Fine adjustment and choice of telemetry protocol via PC setup, suitable USB adapter is optionally available

Technical specifications:

• Input voltage: 22.2V – 44.4V
• Electricity: 135A duration
• BEC voltage: 5.0V – 8.4V
• BEC current: 10A duration, 25A peak
• Cable cross-section battery / motor: 6qmm / 4qmm
• Dimensions: 82×43,5x26mm
• Weight: 122g (without cable) / 178g (with cable)